| Search results - "cutting" |
639 viewsThe exhausts from Phil's 2180 fit almost perfectly on my 1835. Some minor adjustments by cutting and welding will be made at the bottom to get a better exit but time is saved by re-cycling.
|
|
aileron bent on a home builder's flashing break821 viewsThis was a test run on bending the .020 aileron blank on the flashing break I own. It worked very well, no sacrificial piece needed on this type break. Unfortunately, we cut the blank 90 inches instead of 92! anyone need a short pre-formed aileron? LOL - plus we have 3 more too short blanks! Oh well, back to the cutting table.
|
|
763 viewsIt is my turn
|
|
Cutting Wing Spar cap898 views
|
|
143 viewsI used a 3/4 Forstner bit to make these radius holes and lots of cutting pookey.
|
|
651 views
|
|
|
|
|
|
